6
Using memories
The focus HAND3 has 51 memories on board.
Recording a memory
Create the scene as normal.
Next press:
[Func] [- / Store] number of the memory [Enter]
Recalling a memory
Press:
[Func] [+ / memory] number of the memory [Enter]
Using Startup memory
If memory 0 is programmed then the unit will automatically activate in merge mode at power on.
Memory 0 can be programmed with channels at certain levels or with all channels at 0%. To erase
memory 0, store memory 0 with all 512 channels at FULL (best to disconnect the DMX output before
setting all channels at FULL).
Using multiple remotes at the same location
To use multiple remotes in the same location, without interfering, you’ll need to make change some
settings in both remote and base unit. 3 possible settings are possible called: ‘0’ (factory default) ‘+’
and ‘-‘.
Changing the base unit’s encoding
(this may only be done by qualified personnel, because you’ll need to open the cabinet)
•
Unplug the main power supply
•
Open the cabinet (6 screws)
•
Find the location of the settings, it is a jumper array marked by 0 + - (at the front)
•
Set the jumper to the correct setting
•
Close the cabinet
Changing the remote’s encoding
(this can be done at any time, even to use 1 remote for up to 3 locations)
•
Switch off the remote (slide switch)
•
Press and hold the ‘0’ ‘+’ or ‘-‘ key
•
Switch on the remote (slide switch)
•
Wait for a few seconds (keeping the key pressed) until the leds start flashing.
Troubleshooting
If for some reason you can’t get any connection between the HF remote and the base unit. Please first
check the batteries of the remote. If they are ok then the remote might have accidentally been set to a
different encoding. Follow the procedure described above.
General Information
CE – Product
The Focus Hand System permits to the CE requirements set-up by the European Community. This
can be recognized by this label on the outside of the product.
