MEASURES VISUALISATION
The measures reading is visualised on the display
E
, showing the three phase measures (L1, L2 y L3 respectively) of the
indicated parameter by the
C
LED. For measuring the phase to phase voltage (V
L-L
), the three measures are understood
V
L1-L2
, V
L2-L3
, V
L3-L1 respectively, as indicated on the front plate.
The selection of the parameter to be visualised is made by pressing the key
B
. It will be indicated by the
C
LED.
By pressing the key
A,
the selected parameters will be visualised on display
E
, as three phase values (average of the
individual phases for voltages and currents) with the corresponding lighting of the LED, placed internally in the key.
With
LED
Σ
L
turned off and unbalanced three phase system mode (UNBALANC) are displayed in the following
sequence:
-
LED VL-N
ON: On the display are showed the phase voltages
-
LED VL-L
ON: On the display are showed the phase to phase voltages
-
LED A
ON: On the display are showed the phase current
-
LED Hz
ON: on L3 display is showed the frequency measured on L3 phase, on L1 display will appear the
message PHASE ROTATION with a bright dash that rotate clockwise to indicate that the
phase rotation is correct, or the message ERR if the phase rotation is wrong.
-
LED h
ON: On the display are showed the phase hour counters HR1, HR2, HR3. The reading of the
meters uses the 6 digits (maximum reading 99999.9) of the
E
display the measure comes
visualised in such a way that, the display L1 will show the first 3 digits, the display L2 the second
3 digits and the display L3 the identification of the corresponding hour meter (HR1, HR2, HR3).
Each hour counter is activated when the measure of phase corresponding to the selected
parameter exceed the threshold set (see SET HR_). The measure is expressed in hour
(integer) and tenths of hours (decimal).
By pressing the
A
key the LED
Σ
L is enabled and the system values are displayed.
Please note that the unit value may be expressed in kilo, when the corresponding LED
C
are glowing (indicated in the
front plate as
k
).
The visualised frequency is referred to the line L3.
ELM-96
instruction manual
IM425-U v3.1
pag. 12