30
Photo
1
Photo
2
2.
Photo 3 shows the cable after the side panel has been unscrewed, and how it
should run correctly behind the side panel. The cable should be placed as far to
the right as possible behind the panel. This can be done by taking the cable
between two fingers
and pushing it from left to right into the gap inside the
panel. The cable should not form a loop of
slack at the back of the housing but should
run fairly taught from the upper strain relief
device to the red plastic support clip.
The cable slack should only run in the gap behind
the two panels, as shown.
The next two photos show the red plastic support
clip (cable protection) and how the cable should run
from in between the two panels and behind and up
to the strain relief device.
Photo 3
At this point, the cable should run
diagonally upwards. When the machine
is repositioned inside its housing the
cable should not form any slack. Slack
cord between the back panel of the
machine (that needs to be moved in and
out of out of its housing) and the back
panel of the housing (screwed to the
cabinet) will create an obstruction and
prevent proper closing and engagement.
As a result, the limit switch cannot
engage, the machine does not work and
the espresso machine comes out of its
housing every time the drawer is
opened.
Photo 4
Summary of Contents for SUPREME DED400XP1
Page 1: ...EXPRESSO DED400XP1 ...