Guidance
CLE-200
ELCOM-Türsprechanlagen
R
Hauskommunikation für Ihre Sicherheit
Zeichnungsnummer:
AN CLE-200
edition 04.04.2003
Code-Lock for mounting
Programming:
Note:
Switchcode 1:
The codes must be selected in such a way, that these are assigned clearly. (Not allowed: Code1=1234
Code2=123)
If no switchcode is programmed (code programming mode is terminated with the key
former input
of a code) the switching contact may be activated by pushing of the key
.
In order to activate the switch mode, the switch term =0 seconds has to be adjusted. By pushing of the key
,
the current procedure may be aborted.
- push and hold key
, additionally key
, pushed and held for 3 seconds, until audio signal sounds.
- enter current mastercode - audio signal sounds.
- push key
-
.
- enter switchcode and push key
-
without
audio signal sounds
audio signal sounds.
- push and hold key
, additionally key
, pushed and held for 3 seconds, until audio signal sounds.
- enter current mastercode - audio signal sounds.
- push key
- audio signal sounds.
- enter switchcode and push key
- audio signal sounds.
- push and hold key
, additionally key
, pushed and held for 3 seconds, until audio signal sounds.
- enter current mastercode - audio signal sounds.
- push key
- audio signal sounds.
- enter switch trm in sec. (1-99 or 0) and push key
- audio signal sounds.
- push and hold key
, additionally key
, pushed and held for 3 seconds, until audio signal sounds.
- enter current mastercode - audio signal sounds.
- push key
- audio signal sounds.
- enter switch trm in sec. (1-99 or 0) and push key
- audio signal sounds.
- push and hold key
, additionally key
, pushed and held for 3 seconds, until audio signal sounds.
- enter current mastercode - audio signal sounds.
- push key
- audio signal sounds.
- enter new mastercode and push key
- audio signal sounds.
- audio signal sounds
Switchcode 2:
Switchterm 1:
Switchterm 2:
Mastercode:
restore/backup Mastercode:
If your mastercode has been lost, you may backup to factory setting (789) and restore.
- switch off voltage supply.
- push and hold keys
+
+
simultaneousely.
- restart voltage supply
.
factory settings:
current attitudes:
switchcode 1:
................................................
switchcode 2:
................................................
switch term 1:
Sek.
.........................................sec..
switch term 2:
Sek.
.........................................sec.
Mastercode:
................................................
1 2 3
4 5 6
3
3
7 8 9
