60
Operation in registration mode
The functions that are described in the following chapters are used in the registration mode. All financial
transactions are stored in this mode.
If the cash register allows you to use the training mode, you can try the following functions in the training
mode first (sales data are not stored in the memory).
RECOMMENDED PROCEDURES AT THE BEGINNING OF THE DAY
1) Check if there is enough paper on the printer roll for the day. Insert a new paper roll, if necessary.
2) Print out an “X” report and make sure that:
a) date and time are correct,
b) a daily report was executed.
3) Check whether there is enough cash in drawer.
4) Register the initial cash put into the drawer by entering cash value and pressing the
(RA) key.
STATUS AND FUNCTIONS THAT ARE REQUIRED TO KNOW BEFORE
THE BEGINNING OF REGISTRATION
If a key is used for two functions, choose the function in the lower part of the key by simply pressing the key
and choose the function in the upper part of key by pressing the
(
S
HIFT
) key and pressing the key.
Error warning: the
C
LEAR
key
If a function key is used incorrectly or the registration range is exceeded, the cash register issues an error
beep and an error message appears on the display. To recover and correct the condition, simply press the
(
C
LEAR
) key. The error code is cleared from the display. Then enter the correct function or amount.
Cashier log in: the Password key
The cash register can assign a secret identification number (password) for up to six cashiers. Cashier
passwords, as well as names, are programmed in the programming mode. To use the cashier identificati-
on function, enter the numeric password and press the
(
P
ASSWORD
) key. For extra security, press
the
button before the password entry. Display will show a “
ANGE KOD!
“ label. The entered
password numbers are not visible on the display at this time. If an incorrect password is entered, the cash
register beeps twice and remains locked. Enter the correct number and press the
(
P
ASSWORD
) key
to unlock the cash register. The password protection prevents unauthorised use of cash register. If the cashi-
er’s name has been programmed, it will be printed in the receipt header area after the cashier logs in.
Cashier log out: the Password key
If the cash register has been protected from unauthorised use, the cashier should log out by pressing the
(
P
ASSWORD
) key after finishing of registration. Display shows the “
ANGE KOD!
” label and the
cash register is locked until the correct password is entered and the
(Password) key is pressed.
When the cash register is locked, registration cannot be performed and the cash drawer will not open. This
function is used when changing cashiers or when a cashier leaves the cash register.
Summary of Contents for Euro-200TE
