Euro-500TX Handy
© Elcom, s. r. o.
Service manual
38
Euro-500TX Handy
© Elcom, s. r. o.
Service manual
39
4.4 Motor reinstallation
1. Make sure that the ECR is turned off and the external power supply is disconnected. Separate the
front and middle cover from the bottom one (chapter 4.1)
2. Unplug the motor connector (W–M) from the main PCB.
3. Remove the motor cover from the bottom one by unfastening the screws.
4. Turn the motor cover and release the fixing screws of the motor itself.
5. Pull the motor out from its fixation ribbing (direction ridges).
6. Re-solder the motor connector — red wire onto the + motor pin if necessary.
7. Place the new motor into the fixation ribbing and position the motor holders.
8. Tighten the fixing screws so as to catch the motor holders in place.
9. Assemble the front and middle cover back onto the bottom one.
1
4
3
2
7
5
6
3
Index
Quantity
Description
Code
1
2
Motor cover screw 2.9×9.5
M250018
2
1
Winding roll
M040010
3
1
Motor cover
M040189
4
1
Under cover
T16H500
5
4
Screw 2.9×6.5
M250017
6
2
Motor holder
M050081
7
1
Euro 500 Handy winding motor
T02H500
Fig. 4.7 Motor reinstallation
Fig. 4.8 bottom view of motor cover
Tab. 4.5 Table of shown parts
