Euro 500TE Handy
© Elcom, s. r. o.
73
Helpful advice
What to do in case of power failure?
Power failure
This part is important only for registers that
operate without the built-in accumulator.
If you have used the register and a power failure
occurs, it is necessary:
• to switch the register off
• after electric power recovery switch on the
register
• if the register displays the text
Continue
on Sale
it is necessary to complete the
purchase and compare the resulting sum
with the total of registered items within the
purchase; if one of the items has not been
added to the total sum of the purchase but
it was sold to the customer it is necessary to
register it additionally.
Failures of register as a result of
interference in power network
Accidental failures of electronic equipment are
frequently caused by the power network or by
electromagnetic interference. In case of inten-
sive interference in your working area, or in case
of over or under voltage, installation of protec-
tive devices can help significantly. Ask your au-
thorised dealer or service technician for help.
What to do in case of “Recharge battery” signal
Displaying of the
Recharge battery
warns the operator about discharging the built-
in accumulator.
The stage of internal accumulator charge de-
fines the percentage value in the upper left
corner of the operators display. This percent-
age value informs also that power supply of the
ECR is internal accumulator (the external en-
ergizer is not connected). In case the charge is
low (higher percentage value) the ECR displays
the text
Recharge battery
for a short
time and peeps alerting tone (e. g. by receipt
printing when current input is higher). If the
discharge is higher (percentage value is low) the
text
Recharge battery
is displayed all
the time and the ECR peeps alerting and inter-
rupted tone. After this warning the cash regis-
ter can print about hundred receipts.
It is necessary:
10%
Recharge batt.
VOID DISABLED
IN THIS PHASE
Void disabled in this stage of sale.
WAIT PLEASE
ECR executes operation that takes a longer time.
18 fields, choose form
The message will appear during PLU bar-code programming if
a bar-code of length 18 has been read and the first digit of sixth
electronic journal flag is set to 1.
13-SUBTOTAL 18-CHECK
Displays along with the previous message („18fields,choose
from“), after pressing SUBTOTAL key, the ECR will store only
its initial 13-digit part, after pressing CHEQUE key, the entire
18 -digit code will be stored.
15 fields, choose form
The message will appear during PLU bar-code programming if
a bar-code of length 15 has been read and the first digit of sixth
electronic journal flag is set to 1.
13-SUBTOTAL 15-CHECK
Displays along with the previous message („15fields,choose
from“), after pressing SUBTOTAL key, the ECR will store only
its initial 13-digit part, after pressing CHEQUE key, the entire
15 -digit code will be stored.
Call service for mainte-
nance
After printing more than 3 000 000 lines cash register declare,
that it needs preventive maintenance. For aboliton of report after
the start it is required to visit service.
Enter reset CODE
Reset of cash register was provided. It is required to visit service
centre.
