22
Programming the cash register
INITIALIZATION
Before putting the cash register into use for the first time, it is necessary to initialize it. Initialization of the
cash register clears all programmed product items, departments, sales units, surcharges and discounts. All
other settings and register counters are preserved.
Procedure for initialization:
Sequence of steps
Display
Turn the cash register on and using the buttons
(MENU),
TOTAL and
or
enter into the initialization menu
(Main menu – P-mode – Sys. parameter – Initialization)
System param
Initialisering
Press
TOTAL and then confirm the initialization by pressing the
SUBTOTAL button.
Fortsätt?
Ja=ST, Nej=Any
The cash register begins initialization and „Clearing...“ appears on the
display. After successful completion of initialization the display reads:
Store init. OK
GENERAL PROCEDURE WHEN PROGRAMMING IN ”P“ MODE
Before you start programming the cash register, we recommend that you read this chapter at least one time
through!
Note:
If a button has two functions, the function in the lower part of the button is selected by directly pushing the
button; in order to select the upper function, it is necessary to first press the
(SHIFT) button.
Basic rules for navigating in a menu
1) Switch the cash register into the Main Menu by pressing the
(MENU) key and then use the arrow
keys
or
to navigate to the P-mode menu
HUVUDMENY
P-mode
confirm your choice by pressing the
TOTAL. The display shows:
P-mode
PLU
2) By pressing the arrow keys
or
you can navigate through the individual lines of the programming
mode, which are described in more detail in the following chapter.
3) Press the
TOTAL key to enter into the selected item menu, or to confirm (save) a programmed va-
lue. Continue in this way until you have programmed all of the necessary parameters. Or press the
(MENU) key to switch to a menu one level higher (back).
4) After selection of a specific parameter, a value is set either by manually entering a numerical value (pri-
ce, EAN,...), entering text on the keyboard (names of PLU, DPT, sales units,...) or by pressing the arrow
keys
or
. After setting a correct value, confirm it by pressing the
TOTAL, button; the newly
programmed parameters is then printed out.
5) Should you make a mistake when entering a numerical value or text, you can remove the incorrectly
entered character by pressing the
CLEAR button.
Summary of Contents for Euro-50T Mini
