ELCOM Uniq Monitor 215, User Manual

Thank you for choosing the Uniq Monitor. Before you begin using the device, read these instructions to 

become familiar with the device’s features and functions. Be sure to save this manual for future use. It will 

help you solve problems that may arise. The latest version of the manual is freely available on the Web site 

at www.elcom.eu in the Support section.

IMPORTANT NOTICES

Please pay attention to the following notices. They will help you avoid possible damage to the device and 

potential injury which could result from improper use of the device. With damage to the device caused by 

non-observance of the procedures mentioned in these notices, the legal warranty expires due to improper 

handling with the product.

•  The device must be under permanent supervision while “ON“ or in “STAND BY“ mode until it is turned 

“OFF“ by the central switch and disconnected from the electrical system.

•  If you do not plan to use the device, turn off and unplug the device from source of power. Do not leave 

the switched on device unattended! 

•  Use only the power adapter and cable approved by ELCOM. Unauthorized adapters or cables can cause 

batteries to explode or damage the device.

•  Improper adapter connection can seriously damage the device. Any damage caused by misuse is not 

covered under warranty.

•  Do not charge the device when the power cord is damaged or if the electrical outlet is not grounded. 

This may cause electric shock or fire.

•  If the device overheats, starts to smoke, makes strange noises or strange smells, immediately turn off the 

main power switch and unplug the device.

•  Do not bend the power cord or place heavy objects on it. Stepping on the power cord or its disruption 

with heavy object could result in electric shock or fire.

•  During a storm or when the device is out of service for longer, unplug the power adapter from the elec-

trical outlet to prevent electric shock or fire.  

•   Install the product in a place where it will not be exposed to direct sunlight, unusual changes in tempera-

ture (below 0°C and over 45°C) or high humidity. Installation in an unsuitable place could cause damage 

to the casing and electrical components.

•   Upon carrying the product from a cool environment to a warm one, or vice versa, do not switch it on for 

at least 30 minutes.

•   The product should not be operated by a person with wet hands. Water could penetrate to the interior 

and cause damage to the parts.

•   Clean the external surface with a soft, dry cloth. Never use caustic cleaning agents. The use of such 

chemicals could lead to damage to the product. Do not clean the product with sprayed water and do 

not submerge the product in water.

•  If the product is not working properly, take it to an authorized service center technician. Do not attempt 

to repair the product yourself. Do not open the product!

•  Use only the AC/DC adapter provided or an adapter recommended by an authorized dealer. The use of 

other types of adapters may result in damage to the adapter or the product. First connect the power 

cable to the Uniq Monitor, and only afterwards to the power source! Never disconnect or connect a power 

cable, not even a VGA cable, if the Uniq Monitor or a connected display is switched on!

•  Notice: The adapter is designated for interior use only!
•  The use of sharp objects for operating the touch panel can cause serious damage or destroy the touch panel.

23

Introduction