28
HARDWARE INSTALLATION
HARDWARE INSTALLATION
Installing the Customer Display (Optional)
ARNINNG:
Be sure to turn off the power of the Touch Terminal before making any
connection or disconnection.
To confi
gure the COM port voltage setting to +5V, refer to "Main Board Jumper
Setting and Connector Definition" on page
23
1.
Place the Touch Terminal on a soft and flat surface, with the LCD panel facing down.
Remove the cable compartment cover.
(a)
2. Remove the four screws on the stand.
(b)
3. Remove the stand.
(C)
4. Remove the supportive tape from the stand.
(d)
5. Remove the four screws on the stand cover.
(e)
6. Remove the stand cover.
(f)
7. Align and install the customer display into the four threaded standoffs on the stand.
(g)
8. Secure the customer display to the stand with the four screw nuts.
(h)
9. Route the customer display’s interface cable through the cable guides on the stand and
through the cable compartment as illustrated.
(i)
10. Connect the customer display’s interface cable to the RJ-45 COM port on Touch Terminal.
(j)
j
i
e
h
g
f
a
b
d
c
11. Reverse steps 6 through 1 to complete installing the customer display.
HARDWARE INSTALLATION
29
Installing the Secondary LCD Display (Optional)
ARNINNG:
Be sure to turn off the power of the Touch Terminal before making any
connection or disconnection.
1.
Place the Touch Terminal on a soft and flat surface, with the LCD panel facing down.
Remove the cable compartment cover.
(a)
2. Remove the four screws on the stand.
(b)
3. Remove the stand.
(C)
4. Remove the supportive tape from the stand.
(d)
5. Remove the four screws on the stand cover.
(e)
6. Remove the stand cover.
(f)
7. Align and install the secondary LCD display into the four threaded standoffs on the stand.
(g)
8. Secure the secondary LCD display to the stand with the four screw nuts.
(h)
9. Route the secondary LCD display’s power cable and USB cable through the cable guides on
the stand as illustrated.
(i)
10. Connect the secondary LCD display’s power cable and USB cable to the corresponding
ports on Touch Terminal.
(j)
j
i
e
h
g
a
b
d
f
c
11. Reverse steps 6 through 1 to complete installing the secondary LCD display.
Summary of Contents for W-615
