7
en
4 THE CONTROLS
Your gauge is operated by a single button on the top end cap. There are three methods of pressing
the button:
5 THE DISPLAY
Your gauge is equipped with two LCD
displays.
•
One display shows the gauge settings
and memory location menu items.
•
The other display shows measurement
readings.
5.1 GAUGE SETTINGS AND CONTROL
DISPLAY
The gauge settings and memory locations
are displayed as a set of top level menu
items, each of which has one or more
submenu items.
There are two menu structures used by the gauge. Choice of menu structure is determined
automatically by the gauge and depends upon the type of transducer fitted to the gauge; dual
element type or single element membrane type.
Method
Action
Notes
Press and Short
Hold
Enters into, or
exits out of the
menu struc-
ture.
If entering into the menu structure,
Enter
is displayed,
followed by scrolling through the top level menu items.
If exiting the menu items,
Exit
is displayed, and then the
display shows either the current storage location (i.e.
A1
),
or
MEMOFF
if data storage has been disabled.
Once either instance has occurred, the button must be
released.
Press and
Release
Selects a
menu item.
To select a top level menu item, press and release the but-
ton. The submenu items will begin scrolling on the display.
To select a submenu item, press and release again.
Press and Long
Hold (10 sec-
onds)
Switches the
gauge on and
off.
See “Switching on/off” on page 6.
Measurement
Settings and
readings
memory
