V
V
I
I
P
P
C
C
L
L
A
A
M
M
P
P
M
M
I
I
N
N
I
I
At any time, a long press on the key will quit the MIN/MAX mode.If the INRUSH function was selected (see description
§ 3.7), a short pressure will return to MIN/MAX mode.
Note:
In MIN/MAX mode, the Automatic stop function of the unit is unavailable (symbol )
- Hz
A short press displays the frequency of the measured signal, another press switches back to the previous value.
This key is active only for the AAC, VAC and W functions.
- Short pressure:
display backlight command.
Automatic shutdown after 2 minutes.
Held pressure:
display of estimated remaining battery power, expressed in hours (except INRUSH
and phase order functions).
HOLD key/ switch combination
(see description § 3.12):
- Suppression of automatic stop function
- Activation of the V-Live function
- Display of the internal software version
Yellow key/ switch combination
(see description § 3.12):
- Modification of audio indication threshold in continuity test -Default configuration of the unit
MIN/MAX key/ switch combination
(see description § 3.12):
-Date of last calibration performed on unit
Liquid crystal display
The liquid crystal display includes the digital display of the measured values, the related units and symbols.
Digital display
4 digits, 9999 points, 3 decimal points , + and - signs (DC and peak measurement).
+ OL
: Positive value range exceedance (> 3999 points)
- OL:
Negative value range exceedance
OL:
Unsigned value range exceedance
- - - -: Indeterminate value (middle
Symbol display
Flashing
, clamp power limited to approximately 1 hour
Steady
, battery drained, clamp operation or accuracy no longer guaranteed
Constant operation (no automatic shutdown)
ON
steady when the INRUSH function is selected
Fixed:
Continuity measurement
Flashing:
V-Live function selected
HOLD
Function active
PEAK
ON in V and A in MIN/MAX mode if the measurement of the peak value is selected
MAX
Indicates the display of a maximum value in MIN/MAX mode
MIN
Indicates the display of a minimum value in MIN/MAX mode
OK
Symbol which goes on during the phase rotation direction detection sequence
W
, if power factor display is
selected (yellow key)
PF
Goes on steady, for switch position
AC M
easurement in AC manual mode
Flashing:
measurement in AC automatic mode
DC Fixed:
measurement in DC manual mode
Flashing:
measurement in DC automatic mode
Semi-conductor test on position
3Ø Power measurement on balanced 3 phases system.
2
