www.flash-butrym.pl
2
1
INTRODUCTION
Thank you for purchasing 4 BEAM 4x10W LUMILUX LED RGBW 4in1. For safety reasons and to ensure the
trouble-free operation, carefully read the instructions.
2
SAFETY INFORMATION
1.
Installation should be done by qualified personnel in order to minimize the risk of accidental
electric shock
2.
Disconnect the power supply before installation.
3.
Before connecting the unit to the mains, make sure it is not damaged mechanically. If you
notice any signs of damage you should contact your dealer immediately. Do not connect the
device to the mains.
4.
Do not use the device in high humidity conditions and at temperatures above 40° C
5.
To avoid damage please don't use organic solvents to clean the fixture shell.
6.
The device must be installed on stable structures
7.
It should be installed in a well-ventilated place, at a distance of 15cm or more from the walls.
Please check if the fan and ventilation holes are unobstructed.
3
PRODUCT INFORMATION
3.1
Specification
Power consumption: 180W
Power supply voltage: 110 - 220V
Voltage frequency: 50/60Hz
Diode type: 4in1
Number of diodes: 4
Diode power: 10W
Display: LED - 4 characters
Color: RGBW
Beam angle (min): 2,6°
Beam angle (max): 2,6°
Dimming: Linear: 0 - 100%
Flash frequency (min): 1Hz
Flash frequency (max): 20Hz
PAN range: 540°
TILT range: 270°
DMX standard: DMX 512
Control interface: 4 buttons
Operating modes: DMX, Automatic, Sound controlled
Features: Electronic position correction
AC IN: powerCON
AC OUT: powerCON
DMX IN: XLR - 3 pin
DMX OUT: XLR - 3 pin
IP Rating: IP22
Housing made: Aluminium
