elddis encore Owner'S Handbook Manual Download

Page: 57 / 100

9-32

HOW TO USE YOUR MOTORHOME’S EQUIPMENT

18. Push the handle back into its locked

position. Turn the emptying spout
upwards and remove the cap from the
spout. Hold the Waste Holding Tank in
such a way that during emptying you can
operate the vent plunger with your
thumb. To empty the tank without
splashing, depress the vent plunger while
emptying the tank. After emptying, rinse
the tank and blade thoroughly with water.

CAUTION:

Do not seriously shake the tank

or use high pressure water cleaners. This
may cause damage to the tank’s interior.

Note:

The vent plunger should only be

depressed once the emptying spout is
pointing downwards. Prepare the toilet for
re-use if required. Slide the Waste Holding
Tank into the toilet and close the access
door.

Emptying with Optional Features

19. Waste Holding Tank Multi-Level Indicator:

The lower lamp indicates that the Waste
Holding Tank is almost empty; the middle
lamp indicates that it is more than half
full; when the upper lamp lights up, the
tank needs emptying as it can only take 2
- 3 further uses.

Note:

The Waste Holding Tank Level

Indicator will flash when the holding tank is
not present. In this case the toilet will not
flush.

20. Waste Pump-Out System: When

activating the control panel this feature
automatically lights up. When the Waste
Holding Tank Level Indicator illuminates,
press the Waste Pump-Out button to
pump out the waste from the holding tank
into the vehicle’s waste tank. The button
will flash while the waste is being
pumped and will stop automatically (after
approximately 5 minutes) when all waste
has been transferred. If the vehicle’s
waste tank is full, the Waste Pump-Out
light will flash rapidly and no pump-out
will be possible until the central tank is
emptied. (Check the level of the vehicle’s
waste tank on the vehicle’s central
console). After the Waste Holding Tank
has been emptied, there will be

approximately 1.5 litres of waste left in
the tank. This is normal. Add 2 litres of
water and a correct dosage of Thetford
toilet fluids to the Waste Holding Tank.

CAUTION:

It is vital that the correct amount

of toilet fluid is added to ensure the proper
breakdown of the waste in the holding tank.
Only use the system when the tank is full.
Using the system too often on an empty tank
can cause damage to the pump, which could
cause the system to fail.

Cleaning and Maintenance

The toilet should be cleaned and maintained
regularly, depending on the amount of use.
To clean Thetford toilets, we advise using
water and Thetford Bathroom Cleaner.

CAUTION:

Never use bleach, vinegar or

other powerful household cleaners that
contain these substances. These may cause
permanent damage to the seals and other
toilet components.

Toilet Bowl

Squirt Thetford Bathroom Cleaner into
the toilet bowl.

Flush the toilet bowl with water and wipe
down the rest of the toilet with a damp
cloth.

Clean seat and lid The seat and lid can
easily be removed: Lift the seat and lid
assembly and pull the round pins (inside
the assembly) outwards from the pin
holes. After cleaning, replace the seat
and lid by positioning the round pins in
front of the pin holes and push the lid and
seat downwards.

To keep your flush water fresh and to
prevent deposits from forming in your
toilet bowl, add a correct dosage of Aqua
Rinse in your flush water tank, if present,
on your toilet.

Tip!

For a really shining toilet, dry with a soft

dry cloth after cleaning.