4
4. EWK1 Zones (Panic Button)
EWK1 key-fob supports a
Panic Button
feature allowing to cause alarm at any time when the specified button is pressed. This feature
can be configured using
ELDES Configuration Tool
by creating a virtual zone of
Silent
or
24H
type and assigning it to
Virtual Alarm
option. The
Panic Button
feature can be set up on any button of EWK1.
5. Battery Replacement
1. Open EWD1 enclosure.
2. Remove the old battery from the battery slot.
3. Postition the new battery according to the appropriate battery slot positive terminal indicated.
4. Insert the battery into the battery slot.
5. Battery replaced.
See chapter
3. Installation
for more details.
ATTENTION
: Only CR2032 3V batteries can be used. Install only new, high quality and unexpired batteries. Do not mix the old
batteries with the new ones.
ATTENTION
: At least 1 battery must be removed if the device is not in use.
ATTENTION
: In order to avoid fire or explosion hazards, the system must be used only with approved battery. Special care must
be taken when connecting positive and negative battery terminals. Dispose old batteries only into special collection sites. Do not
charge, disassemble, heat or incinerate old batteries.
NOTE
: The battery status can be monitored in real-time using
ELDES Configuration Tool
software.
6. Restoring Default Parameters
1. Remove the battery from EWK1 key-fob.
2. Press and hold button.
3. Insert the battery back to EWK1.
4. Hold the button pressed until LED indicator provides several short flashes.
5. Release button.
6. Parameters restored to default.
7. Additional Information
Limited Liability
The buyer must agree that the system will reduce the risk of fire, theft, burglary or other dangers but does not guarantee against such
events. “ELDES UAB” will not take any responsibility regarding personal or property or revenue loss while using the system. “ELDES
UAB” liability according to local laws does not exceed value of the purchased system. “ELDES UAB” is not affiliated with any of the
cellular providers therefore is not responsible for the quality of cellular service.
Manufacturer Warranty
The system carries a 24-month warranty by the manufacturer “ELDES UAB”. Warranty period starts from the day the system has been
purchased by the end user. The warranty is valid only if the system has been used as intended, following all guidelines listed in the
manual and within specified operating conditions. Receipt must be kept as a proof of purchase date. The warranty is voided if the
system has been exposed to mechanical impact, chemicals, high humidity, fluids, corrosive and hazardous environment or other
force majeure factors.
