The appliance will only function if all parts have been properly assembled and only than the microswitch
will be unlocked.
- always operate the product on a flat, stable surface
- put the plug in the wall socket
- slice products into pieces which fit into the feeding tube that is in the lid (2).
Do not cut products into too small pieces.
- make sure the juice jug (14) has been placed under the juice spout (8).
- make sure that pulp container (13) has been placed under the pulp spout (7)
- switch the appliance on by turning the control knob (12)to the position „ON”
- put prepared fruits/vegetables in the feeding tube and gently press them down towards
the rotating bolt by means of the pusher. Do not exert too much pressure on the pusher, as that
could affect the quality of the end result or evean blocked the appliance.
Never insert your fingers or an object into the feeding tube.
- The juice will flow directly in the juice jug (14), and the pulp will be collectedin the pulp container
(13).
- If the Extracting bolt is locked, you need to set the switch (12) to "R" for 3 to 5 seconds. Repeat the
process two to three times, then turn off, and disassemble items of PERFECT JUICER (see CLEANING
section) to remove the blcking element.
- After you have processed all ingredients and the juice flow has stopped, switch the appliance off
and wait until the filter has stopped rotating
- Make sure you observe the maximum time of continuous operation of the appliance. Exceeding
the time limit and failing to provide appropriate breaks during the operation of the appliance may
cause irreparable damage to the engine.
USING THE APPLIANCE
4
Summary of Contents for Perfect Juicer PJ400
Page 18: ...40 www eldom eu...
Page 19: ......
Page 21: ...PERFECT JUICER 9 2 14 8 13 7 12 On 2 1 14 13 12 R 3 5 2 3 PERFECT JUICER 21...
