Operating instruction
R
JUICE EXTRACTOR SK11A
General description
Technical data
1. Pusher
2. Feeding tuble
3. Lid
4. Filter
5. Juicer collector
6. Juice flowing nozzle
7. Pulp container
8. Main body
9. Lock button
10. Control knob
11. Cap
12. Cover
13. Jug
14. Seal
15. Knife
16. Connector
- power: 250W
- mains voltage: 230V ~ 50Hz
- maximum time of continuous
operation: 1 minute
- break before continuation
of operation: 2 minutes
HOW TO USE THE APPLIANCE
Slide the pusher into the feeding tube by aligning the groove in the pusher with the small protrusion on the
inside of the feeding tube.
Place the juice jug under the spout.
Read these instructions for use carefully before using the appliance
- wash all detachable parts,
- assemble the appliance
JUICE EXTRAKTOR
MONTAGE
Make sure that the appliance is disconnected from power network and the switch (10) is set in „0” position
Align the juice flowing nozzle with the juice outlet of the central holder and install them (if it is already installed,
take the next step directly).
Place the juice collector into the appliance and place the pulp container into the appliance by tilting it
forwards slightly.
Insert the top end first and then push home the bottom end
Put the filter in the juice collector and hold the lid over the filter and lower it into position.
Put the top cover on central holder, press it down to fix it on main body lock catch.
When a “click” is heard, top cover is locked. Otherwise, the product will not work.
6
