3. Remove the juice collector together with the filter
Take off outlet on central holder.
4. Clean these parts with a cleaning brush in warm water with some washing-up liquid and
rinse them under the tap.
5. Clean the motor unit with a damp cloth.
Never immerse the motor unit in water nor rinse it under the tap.
BLENDER
MONTAGE
- make sure that the appliance is disconnected from power network and the switch (10) is set in
„0” position
- the body (8) has to be placed on a flat and stable surface
- install connector (16) on body (8) from right above, slightly press down, when “click” is heard,
lock catch has locked central holder, or else, product will not work
- assemble the jug (13) together with the seal (14) and knife (15). The jug (13) has to be placed
on the connector (16) and turned anti-clockwise
The appliance is equipped in a device which protects it against starting it without the properly
seated jug (13). In case of problems with starting the blender, it is necessary to check whether
the element is properly installed. Do not release the lock (9) during operation of the device.
USING THE APPLIANCE
- place food products in the jug (13). The maximum allowed level is marked on the jug (MAX). In
order to avoid splashing it is recommended not to exceed the volume of 0,75 l.
- place the cover (12) on the jug (13) and block it by means of turning it clockwise
- put the cap (11) into the opening in the cover (12)
- connect the appliance to power
- depending on the products processed, select with a switch (10) low or high speed (item 1 or 2)
- in order to turn on impulse work, one shall turn and hold the switch (10) in „P” position.
After releasing the switch it automatically goes back to „0” position.
After completing work one shall set the switch (10) in „0” position, disconnect the appliance from
network and wait for the knife (15) to stop.
ATTENTION
It is necessary to observe the time of the appliance continuous work. Exceeding working time and
lack of sufficient intervals in the appliance work may lead to irreversible damages to the engine
and loss of guarantee.
In case the appliances blocks while operation, disconnect it from power supply before cleaning
and wait for the knife to stop. It is not allowed to start the blender without the food products
NOTICE
- In order to obtain the best results in preparing pulps and mousses it is necessary to put small
portions of food instead of big ones into the jug.
- In case of processing solid products, it is necessary to cut them into smaller pieces first (2-3 cm).
- Accessories and jug are not adjusted for preparing hot meals.
- It is recommended to use the blender in impulse mode for mixing components of solid consistency
in order to prevent from cutting knives blocking.
CARE AND CLEANING
Before attempting to cleaning, one shall disconnect the appliance from supply network.
The elements of the blender may not be washed in dishwashers or in very hot water.
The body (8) and the knife (15) cannot be immersed in water.
The body may be cleaned with a damp cloth with the addition of washing liquid.
Do not clean the knife (15) with bare hands. Use a brush.
Other elements, that is a cap (11), a cover (12), a pot (13) or a connector (16) may be washed
in warm water with the additional of washing liquid.
Simple cleaning of the jug and knife:
- empty the jug (13) and fill it in with water.
- place the jug (13) on the body (8) and turn the switch (10) for a couple of times into „P” position.
- discharge water from the jug and rinse it.
It is not allowed to clean the appliance with sharp, abrasive cloths or sponges as it may lead to
damaging the appliance.
8
