Centrifuge Extractor 1500, Centrifuge Extractor 3000
45-3810, 45-3815
10
9907X0071 Issue 2
7.4.4 Eye contact
The eye should be thoroughly washed out with running water from a tap or saline
solution from an eye wash bottle. Washing should be continued for at least 10
minutes, holding the eye-lid firmly open and ensuring that the washing liquid enters all
parts of the eye. A doctor should be consulted as soon as possible.
7.4.5 Swallowing
The patient should be given an emetic, such as salty water, to induce vomiting. A
doctor should be called at once.
8 Maintenance
8.1 Routine
8.1.1 The apparatus is designed to operate over long periods with a minimum of
maintenance. However, the following checks are recommended during daily
operation.
8.2 Outer cover bearing
8.2.1 The stabilizing bearing on the cover unit is exposed to the solvent vapors which may
slowly dissolve out the lubricating grease.
8.2.2 It is recommended that on a daily basis, without removing the retaining clips, this
bearing is checked and a portion of general purpose engineering grease smeared
across the bearing cover.
8.2.3 To avoid chattering between the bowl (6) and the spigot (5), the latter is fitted with ten
‘O’ ring rubbers to act as a shock absorber.
8.2.4 As a matter of routine, check the rubbers for signs of damage.
8.2.5 If necessary, remove and replace with ‘O’ rings.
8.2.6 To gain access to these rubbers, it may be found easier to remove the outer bowl (9)
by unscrewing the 4 retaining bolts (15).
8.3 Electrical
8.3.1 The arrangement of the two micro switches as part of the speed controller is carefully
set for the correct operation of the motor and brake. It is recommended that these are
not disturbed.
