Sieve Shaker for 200mm or 8 inch and 300mm or 12 inch diameter sieves
80-0200
8
9907X0058 Issue 2
5.4.4 The display will count down in minutes on the right hand side and stop after showing
the final minute. When the test is finished the time also resets to the current time set
in memory.
5.4.5 At the end of the test the clamp plate (B) and sieve stack may be removed in the
reverse order to which they were assembled.
5.4.6 The sieve shaker may also be stopped at any time during operation by pressing the
(6) button, or in an emergency switch off the shaker by using the mains switch on the
side of the control module.
6
Maintenance
6.1
The sieve shaker is maintenance free other than keeping it clean and free from
debris, especially with regard to the recesses in the lower vibrating plate. The
external surfaces may be cleaned using a mild detergent solution. Under no
circumstances should solvents be used as they will damage the paint finish.
6.2
If at any time the shaker makes a strange noise which cannot be rectified by reducing
the vibration intensity, contact ELE for further information. Do not run the sieve
shaker in this state as serious damage to the internal mechanisms could occur.
7
Trouble Shooting
DANGER :
This work must only be carried out by a competent and approved
person
DANGER :
Disconnect mains electrical supply before removing any covers.
Fault
Possible Cause
Check
With main switch ON
the shaker does not
start
No Supply.
Check main supply is correct.
Fuses blown.
Replace fuses with correct
capacity. Fuses are located
inside the control module.
The display is on and
when pressing button
(5) the shaker does not
start
Wire connection failure
inside the control module.
Open the control module case
and check the various wire
connections.
Failure of the
electromagnetic unit.
Contact ELE service
department.
8
Spares and Accessories
For spares and accessories please contact ELE International.
Summary of Contents for SIEVE-TRONIC
Page 9: ...DIRECTIVE ON WASTE ELECTRICAL ELECTRONIC EQUIPMENT WEEE ...
Page 10: ......
