SOI ONE User Guide
Datasheet support@elecfreaks.com
8
11.
Tips
1
、
Make sure the soldering temperature is 5-10°C above the required temperature. SOI one lasts
longer working under 300°C.
2
、
Don't knock or swing the soldering iron, or it would break or cause poor contact.
3
、
SOI one bit is made of dark technology alloy material. It only requires environmental friendly
resin to solder instead of scaling powder.
4
、
To maximize its endurance, cover the soldering bit with a layer of soldering tin for protection.
12.
Q&A
Question: Why is it that ever since I replaced a new soldering iron bit, the temperature jumps at a
large scale?
Answer
：
This is normal when you use a new soldering iron bit. For the thermocouple is not aged,
so it’s not steady.
Normally, new soldering iron bits need to go through aging processing before using.
Aging process:
1
、
Prepare a big tin bar and a wet asbestos.
2
、
Set the soldering station to the highest temperature.
3
、
Slowly heat the soldering bit, and feed the tin bar when it’s hot enough. Use the tin bar to cool
the soldering bit to avoid overheating. When the temperature of the soldering station is steady,
turn the temperature back to normal. The aging process is completed. For bits that can’t heat,
assist with an iron.
Or, you can just ignore the temperature jump and use it anyway. The temperature will be steady
after 5 times.
13.
Language menus
中文
English Korean
设置菜单
Main menu
메인메뉴
┣基本设置
Base setup
기본셋팅
┃┣运放增益
Amplify gain
증폭계수
┃┣失调电压
Amplify offset
실조전압
┃┗热电参数
Thermocouple
열전
계수
┣待机设置
Standby setup
절전설정
┃┣
待机
温
度
Standby temp
온도설정
┃┣待机时间
Idle time
초과
시간
┃┗唤醒模式
Wakeup mode
동작방법
(
编码
/
震动
) (KNOB/SHAKE) (
핸들
/
진동
)
┣休眠设置
Sleep setup
수면
설정
┃┗休眠时间
Poweroff time
초과
시간
┣加强设置
Boost setup
강화설정
┃┣增加温度
Boost temp
온도강화
┃┗加强时间
Boost time
시간강화
