7
www.elecro.co.uk
EN
G
L
ISH
Digital Thermostat Controller
The digital controller fi tted to the In-Line + heater has been pre-
programmed with all the necessary parameters to ensure reliable service &
operation. Below is a key explaining the controllers buttons & LED signals
however these will all be explained in detail later in this booklet.
Press and hold for 2 seconds to power the control on / off .
Press to increase required pool temperature.
Press to decrease required pool temperature.
Press and release to activate / deactivate ‘Priority of Heating’.
The actual pool temperature is displayed in the red upper display. The
lower green display ‘required temperature’ can be selected by the user.
This is the temperature you would like your pool water to be maintained at.
Priority of Heating is a function that ensures your pool water is constantly
maintained at your required temperature. When Priority of heating is
activated the Priority of Heating Icon on the bottom right of the display
will illuminate. The control will now monitor the pool temperature, and
start both the pool circulation pump and heating process when necessary
- please see pump interlock section for details on how to connect the
pump interlock cable
