Electra Roller, How To Install

Assigning additional channels with a 4 channel control

All 4 lights  will 
light up when 
the fifth 
channel is 
selected

This is your 
channel 
selector 
button. Press 
this repeatedly 
to change 
between 
channels. 

Your 4-Channel 
remote control 

Example: Two blinds with independent control on channels 1 (blind 1) & 2 (blind 2) - set up the blinds for group control so that when 

you press channel 3, blinds 1 & 2 will  operate together).

Step 1 - Select Channel 1 which operates blind 1. 

Step 2 - Using a paper clip, press and hold the program 

button on the rear of the handset until blind 1 jiggles 
(approx 2-3 secs).

Step 3 - Select Channel 3 on the controller. 
Step 4 - Press the program button on the rear of the 

handset until blind 1 jiggles (approx 1 sec). Channel 3 will 
now operate blind 1.
Step 5 - Select Channel 2 which operates blind 2. 
Step 6 - Press and hold the program button on the 
rear of the handset until blind 2 jiggles (approx 2-3 secs). 
Step 7 - Select Channel 3 on the handset. 
Step 8 - Press the program button on the 
rear of the handset until blind 2 jiggles (approx 1 sec). 
Channel 3 will now operate blind 2.

When all programming steps have been completed, Channel 3 will operate blinds 1 & 2 together. All 
other blinds should be disconnected from their respective power while programming is in progress. 

While programming, the blind should not be inactive for longer than 2 minutes or the motor will exit 
the programming mode.

Multi-channel programming

15