Power up & testing-
blind supplied without a control
New blind - Existing Remote control/wall switch
Before you begin
The following instructions are relevant if you already have a remote control/wall switch and selected 'no control needed'
when ordering your Electra blind. The blind supplied has been set up with the up and down stop position preset for your
convenience.
Pairing your remote control/wall switch to your blind
STEP 1: Initiate programming.
Press both up and down
buttons together briefly and
let go - the blind will "jiggle".
A jiggle is a brief up and down
motion .
STEP 2: Pair the control. Press
and hold the programming
button* on the back of the your
handset or wall switch until the
blind jiggles. Your control is
now paired to the blind motor.
Electra Top Tip!
If you have a 4 channel
handset, make sure
you select the channel
the blind is to operate
in before pressing the
programme button.
*How to locate the programming button on your
control:
Single
channel
and 4-
remote
Wall
switch
9
channel
Summary of Contents for Roller
Page 16: ...electrablinds co uk ...
