Repeat the procedure for the next addresses, until 20.
NOTE:
After pressing the key
n times
, wait a few seconds for the
acoustic confirmation of the terminal for
address n
. The terminal will
issue
n beeps
for
address n
programmed in the terminal.
3.
Return to the
SCU
central unit of the installation. Press the
PROG
button for a short time. The red LED turns off. The installation returns
to normal functioning mode.
For programming the
Touch Line
terminals installed in buildings
with a high number of apartments (higher than 15), purchase the
special terminal address programming device from the producer.
EN
5
7
Use of the outdoor panels
EN
Orientable video camera
Electronic display
Touch keyboard
RFID reader
IR LED
(night lighting)
Name 1
Touch key
with the name
of the family
1 Fam. House
8 Fam. House
10-255 Fam.
Apartment building
Name 3
Name 2
Name 1
Name 4
Name 5
Name 3
Name 4
Name 4
1.
STAND-BY
.
The keys with the names of the residents/ the call
keyboard are permanently backlighted during night. The red LED blinks
and signals the possibility of video monitoring.
2.1. CALL + TALK from outdoor panels with maximum 10 families.
Touch the key corresponding to the name of the family you are
looking for. The panel signals the action acoustically, with a ding-dong.
The call lasts maximum 1 minute. Each touch of the key reinitiates the
call. If the resident answers, the talk mode is activated. The talk takes
place hands-free, during maximum 2 min.
2.2. CALL + TALK from outdoor panels for apartment buildings.
Use the keyboard to dial the number of the desired apartment
(maximum 4 digits). The panel signals the action acoustically, with
ding-dong. The key turns red and the following message appears
on the display:
C
T
P r e s s
a l l i n g :
N a m e 1
o
a b o r t d i a l
The call lasts maximum 1 minute. If you do not know the number of
the apartment, search for the name of the resident in the electronic list
by touching the key.
