4
RESETTING THE TEMPERATURE CUTOFF SWITCH
Should the heater overheat, an automatic cut out will turn the heater off and it will not come back on
without being reset. It can be reset by switching the MAIN ON/OFF SWITCH to OFF and waiting 5 min-
utes before switching the unit back on.
CAUTION
If you need to continuously reset the heater, unplug the unit and call Customer Service at 1-888-346-7539.
MAINTENANCE
WARNING
Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire, electric shock
or injury to persons.
HELPFUL HINTS
It is a good idea to replace all light bulbs at one time if they are close to the end of their rated life. Group
replacement will reduce the number of times you need to open the unit to replace light bulbs.
LIGHT BULB REPLACEMENT
Allow at least 5 minutes for the light bulb to cool off before touching, to avoid accidental burning of the
skin. The light bulb needs to be replaced when you notice a dark section of the flame or when the clarity
and detail of the log exterior disappears. There is on bulb located at the back of the unit behind the access
panel.
LOWER LIGHT BULB REQUIREMENTS
Quantity of 1 clear chandelier or candelabra bulb with an E-12 (small) socket base, and 60 Watt rating.
TO REPLACE THE LIGHT BULB
(FIGURE 3)
1.
Remove the five screws from the access panel, located on the back of the unit, and remove
access panel.
2.
Locate and examine the bulb to determine if replacement is required.
3.
Unscrew the bulb counter clockwise.
4.
Insert new bulb.
5.
Secure access panel to unit.
