8
reMOTe OPeraTIOn
The Fireplace is supplied with an integrated on/off remote control
Note: Ensure that the fireplace 3 position switch is set to the
Remote Control setting. (Up position)
To operate, push the ON button to turn fireplace on, push the OFF button
to turn the fireplace off.
BaTTerY rePlaCeMenT
To replace the battery:
1. Slide battery cover open on the hand held transmitter. (FIGURE 9)
2. Correctly install one 12 volt (A23) battery in the battery holder.
3. Close the battery cover.
FIGURE 9
Off Button
On Button
Battery
Battery
Cover
reMOTe COnTrOl InITIalIZaTIOn
In the event that your remote control ceases to operate your fireplace,
follow these steps to reinitialize the hand held transmitter and the remote
control receiver in the fireplace:
1. Place the
MAIN ON/OFF SWITCH (FIGURE 8A) in the OFF (“o”)
position.
2. Wait a minimum of 5 seconds and then place the MAIN ON/OFF
SwiTCh
in the Remote Control position.
3. Within 10 seconds of changing the switch position, press the ON
button located on the remote control transmitter (FIGURE 9). This
will synchronize the remote control transmitter and the fireplace receiver.
nOTe:
You will have only 10 seconds to perform this last step. Failure
to do so will result in these steps needing to be followed again.
If you are still experiencing issues with your remote control, contact
Electralog Customer Service at 1-888-346-7539.
www.sylvane.com 1-800-934-9194
