7
6.
WITH POWER ON
, in order to
feed cable, the operator must
move the feeder control lever from
NEUTRAL
(the position midway
between FORWARD and REVERSE)
to the
FORWARD
position, while
depressing the foot actuator. (See
Figure #2 for
FORWARD
feeder
position)
Figure 2
NOTE:
The speed at which the cable
is fed initially can be controlled by
moving the control lever toward
FORWARD
to increase speed and
moving back toward
NEUTRAL
to
slow speed.
NOTE:
If the feeder control lever is
initially put in
FORWARD
but the
cable is not advancing, then turn the
cable tension knob in a clockwise
direction until the cable begins to
advance. (See Figure #3)
DO NOT
over-tighten cable tension
knob as it may damage feeder
bearings.
Figure 3
7. Continue to automatically feed
cable until obstruction is met.
When cable begins to drag or
rotation becomes difficult, move
the lever to the
NEUTRAL
position and allow tool to cut
away at the obstruction. (See
Figure #4 for
NEUTRAL
feeder
position)
Figure 4
DANGER: NEVER
force the cable
or tool into the obstruction. Choose
the proper feeding speed in order to
give a smooth cutting action.
