EHC Electric Combination Radiators –
Installation and technical manual
Page 10
4.
Operating instructions
TEI-1 OPERATING INSTRUCTIONS
Each radiator has a temperature sensor
installed on the underside of the
radiator. This is designed to accurately
determine the room temperature – note
that this should protrude 50 to 70 mm
from the locating screw.
The TEI-1 is operated by turning the control knob. The temperature can be regulated
from approx. 10°C to 30°C, including a frost protection setting of approx. 5°C.
setting
¾
:
approx. 5°C (frost protection)
setting between
¾
and 1:
approx. 10°C
setting 4:
approx. 20°C
setting 6:
approx. 30°C
The red indicator above the control knob indicate the heating status:
LED lit:
heating on or the set temperature has not been reached.
LED not lit:
heating off or the set temperature has been achieved.
CAUTION
- Forced turning beyond the end settings of the control knob will cause
damage to the thermostat components and as such will invalidate the warranty.
5.
Operating safety
This appliance complies with the European Standards EN 60 335-1, EN 60 335-2-61, EN
61000-3-2, EN 61000-3-3, EN 55014 and EN55104 for Safety & Electromagnetic
Compatibility. These standards cover the requirement of the EMC Directives 89/336 &
73/23
RADIATOR POSITIONING
- A minimum clearance of 150mm to the front of the
radiator is essential for safety, however to enable the radiator to attain its maximum
performance ensure that any furniture or other obstruction is not placed closer than
250mm.
THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE
REFERENCE
IMPORTANT SAFETY INFORMATION
CAUTION - THE SURFACE OF THIS RADIATOR CAN BE HOT.
The surface temperatures of this radiator are within the requirements of EN60-335 the
European Standard covering the safety requirements of electric heating appliances, and
momentary contact with any part of the radiator should not cause injury.
However, in order to be effective, radiators of any type do get hot, especially around
the air outlet grille.
Corner equipment below
