12
GREASE MESH FILTERS
The mesh filters can be cleaned by hand. Soak them for about 3 minutes in water
with a mild detergent then brush it gently with a soft brush. Do not apply too much
pressure, or this may damage them. Leave to dry naturally out of direct sun light.
Filters should be washed separately to crockery and kitchen utensils. It is advisable
not to use rinse aid.
INSTALLING GREASE MESH FILTERS
To install filters:
1. Angle the filter into the slots at the back of
the hood.
2. Push the button on handle of the filter.
3. Release the handle once the filter fits into
position.
4. Repeat to install all filters.
CARBON FILTER (not supplied)
Activated carbon filters can be used to trap odours. The activated carbon filter
should be changed between three and six months according to use. The installation
procedure of activated carbon filters is as below.
1. Align the protruding lug of the carbon filter with
the slot in the fan (see arrow A below)
2. Push the other side of the carbon filter toward
the fan to make it flat (see arrow B), and then
press the filter into the fan.
3. If you want to remove the filter, pull the fastener
of the filter and remove it by turning anticlockwise.
NOTE:
•
Make sure the filter is
securely locked. Otherwise, it
may become loose and be
dangerous.
•
With activated carbon filters
fitted you may notice is suction
power is slightly reduced.
Filters for eiQ52GCANOPY
Grease Filter
eiqgf7628
Carbon filter
eiqmidcarbon
