14
INSTALLING THE CARBON FILTER (OPTIONAL)
1. Remove the grease filters from the underside of the hood.
2. The carbon filters are located at either end of the motor.
TO FIT: Locate the filter on the peg on the side of the motor. Rotate the
filter clockwise onto the motor housing;
TO REMOVE: Rotate the filter anti-clockwise until it is unscrewed.
WARNING
: The carbon filter cannot be washed or recycled. It should be
replaced after approximately 2-3 months of use.
When the activated carbon filters are attached, the suction power will be
reduced.
NOTE:
The optional carbon filter is available from the hood
supplier/manufacturer under the following stock code:
eiqcf152
