8
INSTALLATION
•
Unpack the hood and check that all functions are working. Ensure that
the voltage (V) and the frequency (Hz) indicated on the serial plate
match the voltage and frequency at the installation site.
•
Check that the area behind the installation surface is clear of any
electrical cables or pipes, etc to avoid damage when drilling.
•
The surfaces of the hood can be very easily damaged during installation.
Take care with tools to protect the surfaces during installation.
•
Protect the hob surface with cardboard, or similar, to prevent damage
occurring whilst the hood is being installed above.
•
The manufacturer shall not be liable for any failure to observe all
safety regulations in force for the correct and normal operation of
electrical products.
•
Ensure the wall is level and the installation plates are horizontal to
prevent grease from accumulating within the hood.
•
Ensure the power has been turned off at the mains before starting
installation.
•
Connection to the mains supply must be in an accessible location.
•
You may need the following tools to complete this installation:
•
Drill appropriate for your wall
•
Phillips Screwdriver
•
Tape Measure
•
Electrical wiring must be done by a qualified professional in accordance
with all applicable codes and standards, including fire rated construction.
IMPORTANT
•
Sufficient air is needed for proper combustion and exhaustion of gases
through the flue (chimney) for fuel burning equipment to prevent back
drafting. Ductless fans must always be vented to the outdoors.
•
When assessing the air pressure, the entire ventilation system in the
house/apartment must be taken into account.
•
All legal regulations must be observed for the conveyance of exhaust air.
If the extractor hood is used in recirculating mode with the optional
carbon filter, there are no operating restrictions.
Summary of Contents for eiQCURV60EN
Page 18: ...18 PRODUCT FICHE eiQCURV60EN ENBL...
Page 19: ...19 eiQCURV90EN ENBL...
