PROGRAMMING THE PRESETS
The presets are fully customisable. To program a preset
1. Open the microwave door and hold the
“1” button for 5 seconds.
The microwave will bleep to indicate you have entered the programming mode a
nd “ProG”
will be displayed on the screen.
2. Press the preset number you wish to amend (Type the number if set to 100 presets
– See the Microwave Settings section)
3. Type in the cooking time required, eg for 1minute and 25 seconds, press 1, then 2,
then 5. (Please note it cannot exceed the maximum cooking time
– See Microwave
Settings section )
4. If the power level required is not 100%, choose the desired power level by pressing
the appropriate power level button on the control panel.
The power level selected will be displayed on the screen
5. To change the cooking factor (The percentage increase when the X2 button is
used), press the X2 button, and the first number of the percentage required. i.e. to
set it to 50% press the X2 button, followed by 5.
6. Press the
button to save the program.
If the cooking time set exceeds the maximum cooking time, the oven will bleep 3 times,
please restart from step 3 with a shorter cooking time.
7. Close the door or press
to exit programming mode.
MULTI STAGE COOKING
It is possible to use multi stage cooking to set a maximum of 3 cooking stages. Multi stage
cooking can be set both for manual operation and as a preset cooking option. To do this,
once the time and power level have been set for the cooking stage, press the
button
before entering the settings for the second and third stages. Once the stages have been
entered, press the
button.
Example: To create preset 3 as multi stage, with the first stage at M.High for 1 minute 25
seconds, and the second at Med, for 5 minutes and 40 seconds follow the steps:
1.
With the microwave in standby, open the door, and hold “1” for 5 seconds
2.
Press “3” to amend the preset on button 3.
3.
Press “1”, “2”, “5” to input the cooking time.
1:25 will display on the screen.
4. Press
and
PL7 will display on the screen.
5.
Press
to confirm the first stage,
S-2 will display on the screen to indicate entering
programming for stage 2
6. Pres
s “5”, “4”, “0” to input the cooking time.
5:40 will display on the screen
.
7. Press
and PL5 will display on the screen.
Press
to save the program.
Level
High
M. High
Med.
Defrost
Hold
Power
100%
70%
50%
20%
0%
Display
PL10
PL7
PL5
PL2
PL0
11