10
7. The 2 x air flaps should be installed at this
stage, as access is easier before the unit is
wall mounted. On the top of the Hood Unit
itself, where the air outlet vent is located, the 2
x flaps should be carefully installed, bending
very slightly so the lugs at each end locate into
the holes, enabling flaps to pivot upwards
when the unit is in operation, opening up the
outlet fully for the air to pass through. Please
note
– the small spindles/lugs at each end of
each flap locate into the holes
on the housing,
not the grooves above them:
9. Put the chimneys back onto the cooker hood. Hook the
outer chimney onto plate II. Lift up the inner chimney to the
desired height and hook in onto plate I. Alternatively Plate I
can be attached to the chimney using 2 x 10mm screws
(Supplied)
.
10. Plug the power lead into
the power socket (or if
connecting directly to the
mains via a switched spur,
ensure the work is carried
out by a competent,
qualified person) and the
cooker hood is then ready
for use.
Summary of Contents for eiQTMS60BL
Page 8: ...8 INSTALLATION...
