6
PATIO HEATER ASSEMBLY
Required Tools: Philip Screwdriver and Adjustable Spanner.
Leak Detection Solution: One-part detergent and three parts water
Before assembly, ensure all packing material and any transit protection is removed.
Line up holes on the bracket of the wheel assembly (M)
with the corresponding holes on base (L). Then insert
M8 x 16 mm bolts (BB) through the holes. Hand tighten
with the M8 flange nuts (AA). Be sure the wheel
assembly (M) is parallel to the base (L).
Put the Post (K) on the top of the Housing (E), place the
Reinforced Ring (II) under top of Housing (E). Secure
the post (K) and Reinforced Ring (II) using the M6 x 16
mm Bolts and M6 Nuts (CC), Lock Washers (JJ), Φ6
Washers (DD). Fasten and cover with the Deck Ring
(D).
DD
AA
BB
CC
II
JJ