9
OPERATING INSTRUCTIONS
BEFORE FIRST USE AND AFTER EVERY GAS CYLINDER CHANGE, GAS DELIVERY SYSTEM MUST BE
PURGED OF AIR BEFORE IGNITING! TO DO THIS, TURN THE CONTROL DIAL ANTI-CLOCKWISE TO THE
PILOT SETTING. PRESS THE DIAL IN AND HOLD FOR 1 MINUTE BEFORE ATTEMPTING IGNITION.
BATTERY REPLACMENT
Remove the ignition cap from the BURNER ASSEMBLY (J) by turning cap counterclockwise. Install 1 AAA battery. The
negative end of battery goes in first, then replace the ignition cap by turning the cap clockwise.
TO LIGHT THE PILOT
•
Check all connections prior to each use.
•
Turn on the gas supply at source.
•
Press and turn the control dial anti-clockwise to the
PILOT
marking.
•
Hold the dial down and press the
IGNITION
button repeatedly
until the pilot flame is lit, then continue to hold the dial down for
10 seconds until the pilot remains lit after releasing the dial.
•
If the pilot fails to ignite, press and turn the dial clockwise to
OFF
before repeating the lighting steps.
TO LIGHT THE PATIO HEATER
•
The pilot should be lit and the dial set to
PILOT
.
•
Hold the dial down and turn anti-clockwise to the
LOW
position.
•
When the mesh glows, turn dial clockwise to select the desired heat output.
Note: The burner may be noisy when initially turned on. To eliminate excessive noise from the burner, turn
the control dial to the pilot position. Then turn the dial to the level of heat desired.
RE-LIGHTING
•
Turn the Dial to the OFF position.
•
Wait at least 5 minutes, to let gas dissipate, before attempting to re-light pilot.
•
Repeat the “Lighting” steps.
TO EXTINGUISH
•
Hold the dial down and turn clockwise to the OFF position
•
Turn off the valve on the gas cylinder or the regulator after use.
•
Disconnect the gas bottle and allow this appliance to cool before moving the appliance.
Note: After use, some discoloration of the emitter screen is normal. Turn off the regulator after use and allow
the appliance to cool before moving.
PILOT
IGNITION
OFF
HIGH
LOW
