ELECTRO FREEZE Shake Model CS700-FG
185231-17
7
4 Part Names and Functions
— continued
1.) HEAD - ASSY. DISPENSE:
Encloses
the freezing cylinder and provides an
opening for product to be dispensed.
2.) BUSHING - BEATER BEARING:
Holds the beater in place at the front of
the cylinder. Must be inserted into the
head and lubricated before assembly.
3.) O-RING - HEAD:
Seals the head
to the freezing cylinder. Must be
lubricated.
4.) O-RING - PLUNGER LOWER:
Seals
the plunger in the head. Must be
lubricated to seal and slide properly.
5.) O-RING - PLUNGER UPPER:
Seals
the plunger in the head. Must be
lubricated to seal and slide properly.
6.) PLUNGER:
Seals the product opening
in the head when closed. Allows product
to flow when open.
7.) ROD - ACTUATOR:
Starts the freezer
when dispensing. Must be in place
before freezer will operate.
8.) SPINDLE - ASSY.:
Mixes the shake
as it is dispensed.
9.) O-RING - SPINDLE:
Holds the spindle
or pivot post in place.
10.) HANDLE - DISPENSE:
Opens and
closes the plunger to start and stop the
flow of product from the freezer.
11.) STUD - ASSY.:
Hand knobs screw on
studs to hold head assembly in place.
12.) KEEPER:
Secures the handle to the
head.
13.) BAR-SLASH SHIELD:
Attaches the
splash shield to the dispense head.
14.) KNOB - HAND:
Secures the head to
the freezing cylinder.
The following part names and descriptions refer to figure 4-1.
Summary of Contents for CS700-FG
