18
184599
ELECTRO FREEZE Soft Serve Model SL500
Figure 6-8
Clean beater shaft
Figure 6-7
Clean shaft seal, washer, plunger,
and nozzle
Figure 6-9
Clean hopper and mix
feed port
Figure 6-10 Clean inside of drain tube
Replace worn brushes. Use
only Electro Freeze original
or authorized replacement
parts.
d. The beater shaft inside the front
collar and the hole on the rear flange (figure
6-8).
Important:
Do not leave parts in sanitizer for
more than 15 minutes.
3. Using a warm mild dish deter-
gent solution thoroughly brush:
a. the hoppers and the mix feed
tubes from the hopper to the cylinders.
(figure 6-9).
b. the inside of the cylinders
making certain to clean the back walls.
c. the inside of the drain tube
(figure 6-10). Dip the brush in the dish
detergent solution and force brush into
the drain tube until it stops - repeat until
clean.
4. Then brush the mix feed tubes,
cylinders and drain tube with clear water
following with sanitizing solution.
5. Remove the drip tray and insert.
Wash in a warm dish detergent solution,
rinse with clear water and place in santizing
solution for 5 minutes.
6. Wash the outside of the freezer and
inside of the cabinet with a warm dish
detergent solution. Rinse with clear water
7.3
Cleaning Instructions
(continued)
