Doc
#
E149704 V.1.08
QS - 4
Shark® 200T Quickstart
Electro
Industries/GaugeTech
™
Powered by Innovation™
Connect to the Meter through the RS485 Port:
The Shark® 200 meter has a standard RS485 port that makes connection between the meter and a
laptop PC very simple.The Shark
®
200 meter’s RS485 port uses standard 2-wire, half duplex architec-
ture.
Factory Initial Default Settings:
When the Shark
®
200 is powered up, for 10 seconds you can
connect to the meter using the Factory Default Settings (even if the Device Profile has been changed).
After 10 seconds, the Device Profile reverts to the actual Device Profile in use. This is one way you can
always connect to the meter. The Factory Initial Default Settings are:
Device Address:1
Baud Rate:57600
Protocol:Modbus RTU
