DC-One
22 Owner‘s Manual
To exit the Recall process without loading a new preset, press the
Edit, Setup or any of the DSP block buttons. (Edit or Setup buttons
will return the display to run-time mode. DSP block buttons will
display the corresponding DSP block edit screen.)
5.8 Preset Store
Edited presets can be stored in one of 20 User Preset
locations. (U01 – U20) To store a preset, press the
Store button. The LCD display will switch to the Store
Program screen. Use the Value Up and Down buttons
to select the user destination. Locations that already
have presets saved in them will display a preset name.
Empty locations will display “?” in the name field. You may select an empty location, or a location of a
preset that will be over-written.
Press the < Select > buttons to navigate
down to the preset name field. Use the
Value Up and Down buttons to select the
field for each letter / symbol character. The
DC-One provides the complete ANSI
character set, including lower-case &
upper-case letters, numerals and symbols. Pressing and holding the Value Up and Down buttons will scroll
rapidly through the character set. Press the < Select > buttons to move to the next or previous character
position.
When the preset is named, press
Store again. If the preset location
was previously empty, the display
will prompt “Are you sure? Press
Store”. If you are overwriting an
existing preset the display will
prompt “Overwrite Preset? Press Store”. In either case, press Store again to proceed and store the new
preset.
To Exit Store without saving the edited preset, press the Edit, Setup
or any of the DSP block buttons. (Edit or Setup buttons will return
the display to run-time mode. DSP block buttons will display the
corresponding DSP block edit screen.)
5.9 Edit
Both Factory and User preset can be edited, but edited presets can only be stored in User preset locations.
Standard Edit Mode
The DC-One defaults to Standard Edit mode wherein, input and output channel parameters are
appropriately linked. (Refer to “Configurations” illustrations to see which channels are parameter-linked for
each configuration.
Linked parameters are always identical in value. For instance, setting a graphic eq curve for Input A, sets
Store
Summary of Contents for DC-One
