Copyright © 2014 ElectroBoss, All Rights Reserved
1. You will need this manual for the safety warnings
and precautions, operating, inspection, maintenance
and cleaning procedures, parts list and assembly
diagram. Keep your invoice with this manual. Write
the invoice number on the inside of the front cover.
Keep this manual and invoice in a safe and dry
place for future reference.
2.The warnings, cautions and instructions discussed
in this instruction manual cannot cover all possible
conditions and situations that may occur. It must be
understood by the operator that common sense and
caution are factors which cannot be built into this
product, but must be supplied by the operator.
3. NEVER use this product for anything other than
its intended use. NEVER modify this product.
Failure to comply with the precautions, warnings
and recommendations in this manual will nullify your
warranty and may result in injury or even death.
4. BE SURE MACHINE IS PLUGGED INTO A
PROPERLY GROUNDED DEDICATED OUTLET
WHOSE ELECTRICAL OUTPUT MATCHES THE
REQUIREMENTS OF THIS MACHINE. NEVER
remove or modify grounding pin; do not use 3-prong
adapters. DO NOT use with power strips or
extension cords if possible. If using an extension
cord, use the shortest cord possible. If the use of an
extension cord cannot be avoided, use a No.14
AWG minimum size cord that is rated for no less
than 1875 watts. ElectroBoss Company is not liable
for damages or injuries resulting from the use of
extension cords or power strips.
5. DO NOT unplug the machine by pulling or
tugging on the power cord. Firmly grasp the plug
and remove from outlet.
6. MAKE SURE that the power outlet, plug and
power cords used are in good condition. Worn,
frayed or damaged plugs, cords and outlets should
be replaced or repaired by a certified electrician who
is properly qualified to meet local safety and
electrical codes. Power supply cords should be
replaced by the manufacturer. AVOID using
extension cords or 3-prong adaptors.
7. To reduce the risk of electrical shock or fire,
MAKE SURE that your unit is properly grounded.
NEVER TAMPER WITH, REMOVE OR CUT THE
GROUNDING PIN!!
8. Make sure your machine is unplugged when you
conduct any maintenance or repair. A qualified
service technician should always perform service or
repair.
9. This product is not intended for commercial use.
10. Do not cover the power cord. DO NOT immerse
cord in water or use in high traffic areas. DO NOT
run cord over carpets or heating sources of
elements. NEVER use with damaged cords or
plugs.
11. INTENDED FOR UPRIGHT, FREESTANDING
USE ONLY. Do not turn upside down.
12. DO NOT operate with missing or broken parts.
13. This product is intended for INDOOR USE
ONLY. DO NOT USE OUTDOORS.
14. Only qualified repair personnel should perform
general service. Service or maintenance performed
by unqualified personnel could result in injury.
15. Do not clean with flammable liquids or cleaners
as this may cause an explosion or fire hazard.
16. ALWAYS unplug the unit before cleaning or
repairs.
17. Use caution when operating around children.
Do not allow children to operate machine or touch
the machine when it is plugged in.
18. KEEP UPRIGHT when transporting. DO NOT
ALLOW TO TILT PAST 45 DEGREES. DO NOT
UPEND OR TURN UPSIDE DOWN.
19. Always allow the unit to warm up to room
temperature before operating.
IMPORTANT - All persons that will operate this equipment must read and
become thoroughly competent with all operating procedures and safety
precautions. Misuse of this equipment may result in death, personal injury,
property damage, fire or electric shock.
GENERAL SAFETY PRECAUTIONS
