Copyright © 2014 ElectroBoss, All Rights Reserved
IMPORTANT - All persons that will operate this equipment must read and
become thoroughly competent with all operating procedures and safety
precautions. Misuse of this equipment may result in death, personal injury,
property damage, fire or electric shock.
Operation Manual
How to Use Your IceBoss Pro
UNPACKING INSTRUCTIONS AND IMPORTANT STEPS BEFORE FIRST USE!
Remove ice maker from packaging materials and verify that all parts are included. Next, clean the
interior of the machine with a soft cloth and tepid or lukewarm water. Remove the ice basket and
clean as well.
Choose a location for your machine that is well away from potential fire hazards and heat such as
stoves, furnaces, burners, radiators, etc. Make sure that a properly grounded outlet is accessible and
capable of supplying sufficient power. There should be at least 6 inches of space between the
machine and any wall or obstruction. CHOOSE A LEVEL SURFACE.
BEFORE PLUGGING IN YOUR MACHINE FOR THE FIRST TIME ALLOW AT LEAST ONE HOUR
FOR THE REFRIGERANT TO SETTLE PROPERLY.
To use your ice machine:
1. Plug in your machine and use the Select button to choose a size of ice cube.
Note: if the ambient temperature in the room is at or below 60 degrees F, choose a smaller size of
cube to prevent them from sticking together.
2. Next, open the unit and remove the ice basket. Add water up to, but not over the level marker.
3. Press the Power button to begin the 6-12 minute ice making cycle (depending upon your ice cube
size choice).
4. Periodically check to make sure that the water level is sufficient. If for some reason the water pump
cannot send water, the Water Indicator light will go on. Press the Power button again and fill the
reservoir with water. Wait at least three minutes for the refrigerant to settle. Then press the Power
button again to restart. The ice maker will stop automatically when the basket is full. Please Note: To
reduce the risk of waterborne pathogens, you should change the water in your unit every 24 hours,
and drain all water if not in use.
How to Clean & Maintain your IceBoss Pro
1. Always clean your ice maker before use with a soft damp cloth, mild detergent and lukewarm water.
Periodically clean the outside of your machine in the same way.
2. Be sure to dry inside and outside with a soft dry cloth.
3. Drain the water from the reservoir when not in use.
