7
HOW TO CONNECT YOUR SYSTEM
( illustration “rear panel”, page 5.)
SPDIF inputs
( See illustration “back panel”, page 5.)
ECM 1 MKII will accept optical SPDIF sources up to 192kHz/24bit on inputs TOSLink1
and TOSLink2. Please use a optical TOSLink cable for this connection. Connect coaxial
sources up to 192kHz/24bit to inputs COAX1 and COAX2. Please use a coaxial SPDIF
cable for this connection.
Analog audio output – balanced XLR
Use the balanced XLR connectors if you have an amplifier equipped with balanced XLR
audio inputs. Connect the balanced XLR audio outputs from your ECM 1 MKII to the
balanced XLR audio input on your amplifier. Observe correct connection on right and left
audio channel.
Analog audio output – unbalanced RCA
Use the unbalanced RCA connectors if your amplifier is not equipped with balanced XLR
audio inputs. Connect the unbalanced RCA audio outputs from your ECM 1 MKII to the
unbalanced RCA audio input on your amplifier. Observe correct connection on right and
left audio channel.
12V trigger Input/Output
( See illustration “rear panel”, page 5.)
Your ECM 1 MKII is equipped with trigger input and trigger output ports. These ports
can be used for automatically putting your ECM and other equipment into, or wake
up from, standby mode. Use the trigger input port for connecting to a trigger output
signal from other equipment. The ECM 1 MKII will power up (leave standby mode)
when a voltage in the range of 8V-20V (AC or DC) is detected on the trigger input
port, and will remain powered on for as long as the voltage is present on the trigger
input port.
NOTE:
The ECM 1 MKII will only react to a change in the trigger signal.
When the detected trigger signal goes from low to high, ECM 1 MKII will wake from standby.
When the detected trigger signal goes from high to low, ECM1 will go into standby.
A low trigger signal is defined as less than 1V (AC or DC).
A high trigger signal is defined as more than 8V(AC or DC). The voltage supplied to the trigger
input must not exceed 20V (AC or DC). A trigger signal is not mandatory to operate the ECM.
Use the trigger output to send the trigger signal to your amplifier, TV, projector or
other equipment that support trigger signals. This signal can be used to automatically
switch on/off the connected equipment when you turn on/off your ECM 1 MKII.
Trigger output is 12V DC. Use a 3,5mm mono jack plug for connecting to trigger
input and trigger output.
Summary of Contents for ECM 1 MKII
Page 19: ...19 ...
