7
How to power up your system
You should always power up your system the following way: Signal sources (CD player, tuner etc.)
first. Allow a 30 seconds warm-up before you turn on the amplifier(s). When switching off your
system: Start with the amplifier(s), then the signal sources.
Loading a Disc
1. Load the disc by gently pushing the drawer marked: ELECTROCOMPANIET towards the rear
of the unit. «Open» is shown on the display.
2. Place the disc on the spindle.Then
place the CD-clamp on the spindle
. The clamp now
securely fastens the disc.
3. Pull the cover all the way home. The CD player must first read and load vital informa-
tion from the disc. This process, indicated by showing “LOADING“ on the display and takes
approximately three seconds. Tracks and total time are displayed.
4. Press start/play and the first track starts to play.
5. When changing a disc, press the stop button on the front panel or on the remote control
before opening the drawer.
6. If the drawer is opened during playback, it will take the disc a few seconds to spin down.
7. Do not touch the disc until it has come to a complete standstill.
Home installation
The RS-232 control port may be used in home installation setups or general usage for controlling
basic functionality on the CD player.
Please refer to document “EMC1MKV RS232 Command Reference V1.pdf” for
further information. This document may be downloaded from www.electrocompaniet.com
NOTE:
Use analog audio output mode (preferably balanced XLR) for the best audio quality from your player.
i
EMC 1_MKV.indd 7
21.11.2019 17:16:40