S E T U P M E N U O P T I O N S
52
Video Setup
The “Video Setup” section of the Setup Menu system allows you to configure video output options. The menu
items in this section are:
Playback Setup
Video Setup
Audio Format Setup
Audio Processing
Device Setup
Network Setup
Exit
Picture Adjustment
Primary Output
3D Mode
3D TV Size
TV Aspect Ratio
TV System
Output Resolution
HDMI 1
Auto
46
16:9 Wide
NTSC
Auto
Setup Menu
Exit
Adjust picture control parameters
1.
Picture Adjustment
: To adjust picture control parameters. The ELECTROCOMPANIET EMP
2 Blu-ray Disc Player provides a wide array of picture controls. Please refer to the
section on page 55 of this manual for details of each control.
2.
Primary Output
: To select the primary video output port. The options are:
•
HDMI
1 – Use HDMI 1 as the primary video output port. This setting will ensure that the
HDMI 1 output gets the best possible picture quality. The dedicated QDEO DE2750 video
processor will be used unless “Source Direct” for output resolution is selected, in which
case QDEO DE2750 video processor is bypassed. Component and composite video output
may not be available or may be limited to a lower resolution based on content source
limitations.
•
HDMI 2
– Use HDMI 2 as the primary video output port. Similar to “
HDMI 1
”, this setting
ensures that the HDMI 2 output gets the best possible picture quality, except that it utilizes
the video decoder in the player to perform necessary video processing, not the DE2750
video processor.
•
Analog
– Use component video as the primary video output port. This setting will ensure
that the component output is always available and displays proper video signals. The video
decoder in the player performs any necessary format conversion, and the DE2750 video
processor is completely bypassed.
NOTE
Copyright control mechanisms encoded on the disc may limit the output resolution of the
component video output. For DVD, if CSS encryption is in use the output resolution is limited
to no more than 480p/576p; for Blu-ray Discs, the output resolution is limited to no more than
1080i, and could be lower if the disc contains the Image Constraint Token.
3.
3D Mode
: To choose the video output mode for available 3D contents at the HDMI output ports.
The options are:
•
Auto
– Output 3D if supported both by the disc content and the display. The player
automatically checks for the existence of 3D content on the disc and the 3D compatibility of
Summary of Contents for EMP 2
Page 1: ...EMP 2 High Performance Balanced Multiformat Player Owner s Manual ...
Page 2: ......
Page 6: ......
