BA1105 Battery Charger—Operating Manual
5
Operating instructions
1. Ensure the input selector switch is in the correct voltage selection your local area
(i.e. 230V or 115V).
2. Ensure that the charger power button is switched off and connect the charger to the
mains power (wall socket).
3. Connect the XLR plug to the machine to be charged. Initially the status LED will
light up after a few seconds and will drop to ≤30% on the LED level indicator. This
will confirm that the charger has recognised the batteries and is ready to charge.
a. If this does not occur check wall socket is turned off and reconnect.
b. If still not occurring there may be a fault with machine or charger. Contact
Electrodrive immediately (see page 4).
4. Turn the power on at the wall socket. Turn the charger power button on.
5. The status LED will blink and the fan will be running while charging.
6. While charging, the LED level indicator will indicate the level of charge.
a. If the status LED does not blink, either the battery or the wiring is faulty. Contact
Electrodrive for a service enquiry immediately (see page 4).
7. When the battery is 100% charged, the charger will switch to a trickle cycle mode.
a. The fan may continue to run for a while after it switches to trickle cycle mode.
8. Turn the charger off and disconnect it from the machine.
