This document is a property of ElectroFlip LLC No unauthorized reproduction is allowed.
9
STORAGE
When all storage space has been used, the LED light will stop blinking and the device will automatically go
into data saving mode then will automatically shut off after data has been saved.
NOTE: Do not remove Micro SD card while the device is turned on, this could lead to data corruption or
loss.
TROUBLESHOOTING
Below are possible issues that you may encounter when using the device. If the issue you are having is not
on the list you may visit our FAQ section or you can contact us
through our websitat our Customer Support number 1-877-686-7495.
SYMPTOM
POSSIBLE REASON
SOLUTION
Fails to Start
Dead battery
Recharge battery
Device jam
Reset then start again
Auto Shut-off
Dead battery
Recharge battery
Device Not Recognized by
PC/Laptop
Connect to PC with power off
Connect to PC with device power
on
USB cable failure
Replace with new USB cable
PC BIOS disabled
Enable USB in BIOS
USB is not supported
Update motherboard driver
PC device jam
Reboot/Restart PC
Data Not Saving
Memory is full
Delete unwanted files
Battery power shortage
Recharge
1.
I cannot see through my sunglasses?
Remove the purple lens protection from the lenses. Both front and back for each lens needs to be
removed. You may use your fingernails to pick at the edge. This protection comes from the factory
to prevent lenses from scratching upon delivery to us then from us to our customers.
