This document is a property of ElectroFlip LLC (www.ElectroFlip.com).
No unauthorized reproduction is allowed.
18
MOVEMENT ALARM
This alarm is much like Geo-Fence but the alarm is triggered by moving the tracker or the vehicle
where the tracker is, beyond a specified distance of 200 meters or more. To activate this alarm, send a
text message containing:
Message Format:
move+password
Text Message: move123456
Reply: move ok
In case of breach, the tracker will send a text message “move” along with the geo-information to the
authorized numbers.
To deactivate the alarm, send a text message containing:
Message Format:
password
Text Message: nomove123456
Reply: nomove ok
OVER-SPEED ALARM
This is an alarm set to monitor the speed and to trigger an alarm if the speed exceeds the defined
speed limit you programmed. The speed alarm may be triggered by changes in the GPS signal reception
even without a real move of the tracking device. Due to this it is recommended not to set the speed limit
below 30km/h.
To setup this alarm, send a text message containing:
Message Format:
speed+pspace+speed
Text Message: speed123456 080 (
Note:
080 mean 80 km/h)
Reply: speed ok
The text message above means that when the tracker’s speed exceeds 80 km/h, the device will send a
text message with the format “
speed+080+Geo-info
” to the authorized numbers.
To deactivate this alarm, send a text message containing:
Message Format:
password
Text Message: nospeed123456
Reply: nospeed ok
NOTE:
The recommended speed should not be less than 30 km/h. For below recommended speed,
the accuracy will be affected by GPS signals drift and others
