Electrohome RR75, Manual

10

Connecting Headphones

1. 

Connect the headphones to the headphone jack on the front of the system

2. 

Use the desired source on the RR75

3. 

Adjust playback volume on the RR75

IMPORTANT: The speakers on the RR75 are disabled when headphones are connected to the headphone jack. To resume 
normal playback the headphones must be disconnected.

Connecting to an Amplifier

The RR75 can be connected to an external amplifier to integrate it into an existing home audio 
system. It is recommended to lower volume on RR75 to 0 when using an external home audio system 
as each device’s volume is controlled independently. The RCA Audio Output signal is not affected by 
the RR75’s volume or EQ settings.

1. 

Connect an RCA cable to the RCA Audio Output on the back of the RR75

2. 

Connect the other end of the RCA cable to an audio input on your amplifier

3. 

Select the audio input on your amplifier

4. 

Set the RR75 to the desired source

5. 

Adjust playback volume on your amplifier

NOTE: Ensure the RCA cable is not connected to a PHONO input on your amplifier as this can over-amplify the audio signal 
causing damage to the amplifier and speakers.