OPERATION
VistaGRAPHX 2500 User's Manual
3-31
Display Slidebars
If checked, will allow direct slidebars to be superimposed over the current image
when an adjustable parameter is selected. These slidebars include volume,
contrast, brightness, position, pixel tracking and phase, and others. If unchecked,
direct slidebars (or any from
codes) will be invisible during adjustment.
Display Error Messages
If checked, on-screen messages will notify you of errors as they occur. See 3.9,
Error Messages.
Lamp Timer Message
If checked, will display a lamp timer message when the lamp in the projector has
exceeded its lifespan (typically 1000 hours, or as defined in the Service menu).
The lamp timer message will time-out (disappear from screen) after 30 seconds.
NOTE: For maximum lamp performance and safety, it is recommended that
display of this message remain enabled — enter a checkmark in the checkbox.
Video Termination
Check this option to terminate the video input (75
S
).
The input should be
terminated unless the signal loops through (continues) to another projector or
display device, in which case the last projector in the chain should be terminated.
Auto Power up
If checked, the projector will automatically power up after a power failure. Note
that unsaved display adjustments may still be lost.
Intelligent Lens System
This option requires motorized zoom and does not apply to this projector.
This primarily read-only menu (Figure 3-15 and Figure 3-16) consists of four
separate read-only menus plus a text editing box used for entering the serial
number of a new lamp. The four menus list a variety of details about the standard
and optional components currently in use on the projector. Refer to these menus
for information about hardware and software versions installed, number of lamp
hours logged, and projector model and serial number. In addition, the Status
Menu identifies the current channel, switcher, slot and frequencies present. Call
up the Status menu whenever you install a new lamp assembly.
Status
'
Summary of Contents for VistaGRAPHX 2500
